Disassembly and Transporting by side the huge Caterpillar 6015B – Sotiriadis Mining Works


While adopting thorough and reliable hauling tactics, there are a number of actions that must be taken when moving a compact excavator from one job site to another. You may reduce loading issues that could slow down your output by following good hauling procedures, such as using the proper-sized transport and towing vehicles and loading, placing, and securing equipment effectively.

Making sure that the transport and towing vehicles are appropriately matched to the equipment is the first step before moving your small excavator from one place to another. The size and capacity of the transport and towing vehicles must be sufficient for the weight of the machine and attached items, according to Archbold. Some smaller pieces of equipment can be moved on a tarlier that weighs 10,000 pounds, but larger pieces of equipment may need a tarlier that weighs 20.000 to 30000 pounds or more. You will probably need a bigger trailer with a higher weight rating if you are moving an excavator along with a few attachments.

Consistency is needed while loading excavators onto trucks to prevent crucial steps from being skipped. Use the proper loading techniques as described by Archbold: When loading or unloading a compact excavator, block or support the back of the trailer to prevent the trailer’s front end from lifting. Before loading the machine, make sure the undercarriage of the appropriate excavator is clear of any mud, sand, or other obstructions. When loading or unloading a small excavator from a trailer, always disengage the auto-idle option. When loading the small excavator onto the trailer, move up the ramp with the end that weighs the most. Since the excavator is probably attached to an attachment, the front of the machine will be heavier.

The third phase in the transportation procedure is also very important, and it is best carried out ᴍᴇᴛʜodically to make sure that every measure is taken. Once the compact excavator is on the trailer, lower the boom, arm bucket, and blade to the floor of the trailer, turn off the engine, and then engage the chains at the front and rear tie-down locations as shown in your operation and maintenance handbook. Numerous tie-down points are offered by some ᴍᴀɴufacturers, which makes it simpler to trailer the machinery. Finally, use the suggested procedures listed in the ᴍᴀɴual to secure the chains and binders. If you are transporting a variety of items to job sites on one trailer, it is especially crucial to affix attachments to secure excavators.

Because procedures are followed consistently and in an organized ᴍᴀɴner, adhering to the fundamentals of transporting compact excavators can also help you save money because it allows for more effective hauling. The next time you transport your excavator to the jobsite, paying ᴄʟᴏsᴇ attention to these three crucial instructions and steps as well as the ᴍᴀɴual’s suggestions can help minimize issues or problems.

Let’s see process disassembly and transporting by side the huge Caterpillar 6015B in the ᴀᴡᴇsome video below.

Thank you for visiting our website! We hope you found soᴍᴇᴛʜing that sparked your interest on our website.

Video resource: Mais Que Incrível

Leave a Reply

Your email address will not be published.